Service 02 — Dayton, Ohio
Gutter Repair in Dayton, OH Leaks, sagging runs and loose downspouts
Most gutter problems are one failed part: a miter that has let go, a hanger pulled out of soft wood, a downspout knocked off its strap. The repair is priced by the part, and you are told plainly when a run is past repairing.
Leak and miter reseal from $95. Re-hang and re-pitch from $6 per foot.
CostDayton, Ohio
How much does gutter repair cost in Dayton?
Gutter repair in Dayton starts at $95 for resealing a leaking corner or end cap. Re-hanging and re-pitching a sagging run costs $6 to $9 per foot, replacing a downspout starts at $120, and replacing a damaged section of gutter up to twenty feet starts at $220.
| Repair | Starting rate | Labor scope |
|---|---|---|
| Reseal a corner, end cap or outlet | $95 and up | Strip old sealant, clean to bare metal, reseal, water-test |
| Re-hang and re-pitch a run | $6–$9 per ft | Remove spikes, add hidden hangers, reset the fall |
| Replace a section up to 20 ft | $220 and up | Cut out damage, form matching gutter, new miters |
| Replace a downspout | $120 and up | New pipe, elbows and straps, extension at grade |
| Reattach a loose downspout | $65 and up | New straps and fasteners into masonry or siding |
| Storm tie-off or take-down | $150 and up | Secure or remove a hanging run to protect the fascia |
A repair visit has a one-hour minimum. If the quote for repairs passes about half the price of a new run, you will be shown both numbers. Rotted boards behind the gutter are priced on the fascia and soffit repair page.
SignsDayton, Ohio
What are the signs a gutter needs repair?
Look for water dripping behind the gutter, dark streaks down the trim or siding, a run that holds standing water a day after rain, gaps between gutter and roof edge, washed-out mulch below a corner, and a damp basement wall under a downspout. Any one justifies a look.
- Drips from the middle of a run. On seamless gutter that is a hole or a failed hanger screw. On sectional gutter it is a connector.
- Drips at a corner. The miter sealant has dried out. This is the most common repair in the valley and the cheapest.
- Water running down the fascia. The gutter back is in front of the drip edge, or there is no drip edge, so water gets behind.
- A visible belly. Hangers have pulled or the run was never pitched. Standing water breeds mosquitoes and adds weight every time it freezes.
- Overflow in ordinary rain. Usually a blocked outlet. If it is clean and still overflows, the gutter or downspout is undersized for the roof.
- Peeling paint or soft wood. If the board behind the gutter is soft, it has to be replaced before any gutter repair will hold.
Walk the house during a steady rain with an umbrella. Ten minutes of watching where the water goes tells you more than any inspection on a dry day.
DecideDayton, Ohio
Should I repair or replace my gutters?
Repair when the gutter metal is sound and the trouble is at joints, hangers or downspouts. Replace when the run is sectional and leaking at several connectors, when the metal is creased or rusted through, when the gutter is undersized for the roof, or when repairs would cost more than half a new run.
| What we find | Repair | Replace |
|---|---|---|
| One or two leaking corners | Yes — reseal | No |
| Run sagging, metal undamaged | Yes — new hangers, re-pitch | No |
| Sectional gutter leaking at several joints | Short-term only | Yes — seamless run |
| Crease from a ladder or fallen limb | Section swap if short | Yes if the run is bent along its length |
| Overflow with clean outlets | Add a downspout if possible | Yes — move up to 6-inch |
| Rust-through on steel gutter | No | Yes |
The honest version of this table is that aluminum gutter rarely wears out. What wears out is the fastening and the sealant. A twenty-year-old seamless run with new hangers and resealed corners has years left in it.
LeaksDayton, Ohio
How is a leaking gutter corner fixed?
The old sealant is scraped and wire-brushed out, the joint is cleaned to bare metal and dried, and a bead of gutter sealant is tooled across the full seam from inside the gutter. Loose miters are riveted or screwed tight first. The joint is flood-tested once the sealant has skinned.
Sealing over old sealant is why so many corner repairs fail within a year. New sealant bonds to clean aluminum, not to a chalky layer of the last repair. The surface also has to be dry, and the air close to 40°F or warmer, which is why winter leak calls are sometimes patched temporarily and finished on the first mild day.
Why do gutters sag or pull away from the house?
Three causes, usually together. Spikes loosen as the wood around them swells and shrinks. Hangers are spaced too far apart, so each one carries more than it should when the run fills with wet leaves or ice. And the fascia softens where water has been getting behind the gutter. The fix follows the cause: screwed hidden hangers at 24 inches, a re-set fall, and new wood wherever a screw will not bite.
What about storm damage?
Wind, hail and fallen limbs are common in the Miami Valley; the Memorial Day 2019 tornadoes damaged roofs and gutters from Trotwood across Old North Dayton to Beavercreek. Photograph everything from the ground, then call. A run hanging by one end is taken down or tied off first so it does not peel the fascia with it, and the written scope is laid out so it can go straight to your insurer.
When the wood behind the gutter is soft
A re-hang only holds if the screws bite. Where they will not, the board is replaced first; see fascia and soffit repair in Dayton.
QuestionsDayton, Ohio
What do homeowners ask about gutter repair?
Common questions are whether a hole can be patched, whether one section can be replaced to match, how quickly a repair can be scheduled, and whether repairs can be done in winter. Short answers are below; a photo sent by text usually gets you a price range the same day.
Can a hole in a gutter be patched?
Small holes are patched from inside with an aluminum patch bedded in sealant. Rust holes in steel gutter spread, so a patch there buys a season.
Can you match one new section to old gutter?
Usually. K-style profiles are standard and coil colors are consistent across suppliers. Sun-faded gutter will look slightly different beside new metal for a year or two.
Can gutters be repaired in winter?
Hangers, downspouts and re-pitching can be done in the cold. Sealant work waits for a dry day near 40°F or above.
RelatedDayton, Ohio
What other gutter work is done around Dayton?
Beyond repairs, the crew installs seamless gutters, fits gutter guards and cleans gutters across Dayton, Kettering, Beavercreek, Huber Heights, Fairborn and Centerville. Many repair calls begin as a cleaning, because a blocked outlet and a leaking corner look the same from the ground.
- 01Gutter InstallationSeamless aluminum and copper, roll-formed in your driveway and hung on hidden hangers.from $7/ft
- 03Gutter GuardsStainless micro-mesh and perforated aluminum covers fitted to the gutter you have.from $4/ft
- 04Gutter CleaningHand-cleared runs, flushed downspouts and a written note of anything failing.from $125
- 05Fascia & Soffit RepairRotted fascia behind the gutter replaced, then the gutter hung back on sound wood.from $8/ft
- Kettering guttersPostwar ranches and Cape Cods south of Dayton
- Beavercreek guttersGreene County two-stories off US-35 and I-675
- Huber Heights guttersBrick ranches along Brandt Pike and Old Troy Pike
- Fairborn guttersOlder Osborn streets and newer builds near Wright State
- Centerville guttersSteep roofs under mature oaks in Washington Township
See all rates on the Dayton gutter company home page.